Install guide

MP.11 and MP.11a Quick Install Guide

3. Press the RESET button on the indoor MP.11/MP.11a unit. After approximately 90 seconds you are

prompted for your password.

RESET

RELOAD

4. Enter the default password public.

Management

To view or change basic system information, click the Configure button on the left side of the Web interface

window, then click the System tab.

SELECTING A COUNTRY

The Tsunami MP.11/MP.11a provides a selectable Country field that automatically provides the allowed band

and frequencies for the selected country as well as, where applicable, Dynamic Frequency Selection (DFS) and

Transmit Power Control (TPC). A country selection with DFS enabled causes the MP.11a Base Station to come

up in scan mode. It scans the available frequencies and channels to avoid radar and select a channel with the

strongest signal.

By default, the Tsunami MP.11/MP.11a lets you transmit at the maximum output power for the country or

regulatory domain and frequency selected. However, with Transmit Power Control (TPC), you can adjust the

output power of the unit to a lower level in order to reduce interference from neighboring devices or to use a

higher gain antenna without violating the maximum radiated output power allowed for your country

MP.11/MP.11a kits sold in the United States are pre-configured to scan and display only the outdoor frequencies

permitted by the FCC. No other Country selections, channels, or frequencies may be configured.

MP.11/MP.11a kits sold outside of the United States and Canada support the selection of a Country by the

professional installer. Click the Configure button and the System tab; then select the appropriate country for your

regulatory domain.

Continue configuring settings as desired; then click the Commands button and the Reboot tab to save and

activate the settings.

CHANGING THE IP CONFIGURATION

To change the IP Configuration, click the Configure button and the Network tab; then click the IP Configuration

tab.

CONFIGURING INTERFACES

To configure the Ethernet and Wireless interfaces, click the Configure button and the Interfaces tab.