Specifications

Configuration MP.11 5054-R/2454-R Installation and Management
Interface Parameters
78
Base Mode – Non-US Country
The differences between the BSU Wireless interface screen for a non-US country and the equivalent screen for the US
are:
•There is no Turbo Mode.
• Frequency Channel is not configurable. Instead the channel is auto-selected by the DFS process.
For descriptions of all the other fields that appear in both the US and non-US screen for the BSU, see Base Mode – US
Country. In addition, the BSU screen for non-US countries contains these additional fields:
• DFS Preferred Channel: A single DFS preferred frequency channel on the BSU is provided so that when the DFS
process starts the BSU will first try the DFS preferred channel before scanning all the other active channels in the DFS
channel list. The DFS preferred channel must be selected from those channels indicated as “Disable” in the DFS
channel blacklist list. It is not possible to select the DFS preferred channel from those channels in the DFS channel
blacklist list indicated as “Enable”.
• Channel Blacklist Table: The DFS channel blacklist table shows all the channels in the current bandwidth and
specifies the blacklist status of each channel as one of the following:
– Enable – Channels that are made unavailable either for a certain period of time upon detection of a radar signal,
or permanently because the operator has configured them as blacklisted. These channels are skipped over during
DFS channel selection.