Specifications

Configuration MP.11 5054-R/2454-R Installation and Management

Network Parameters

NOTE: To enable roaming, you must enable Roaming Status on both the BSU and the SU.

Enable and Configure the DHCP Server

Click Configure > Network > DHCP Server to enable the unit on a DHCP Server. The Gateway IP Address and

Primary DNS IP Address must be entered, there must be at least one entry in the DHCP Server IP Pool Table, and the

DHCP Relay Agent must be disabled, in order to enable the DHCP Server.

When enabled, the DHCP server allows allocation of IP addresses to hosts on the Ethernet side of the SU or BSU.

Specifically, the DHCP Server feature lets the SU or BSU respond to DHCP requests from Ethernet hosts with the

following information:

• Host IP address

• Gateway IP address

• Subnet Mask

• DNS Primary Server IP address

• DNS Secondary Server IP

The following parameters are configurable:

• DHCP Server Status: Verify that DHCP Relay Agent is disabled. After you have made at least one entry in the DHCP

server IP Pool Table, enable DHCP Server by selecting “Enable” from the DHCP Server Status pull-down menu.