Specifications

Installation and Initialization MP.11 5054-R/2454-R Installation and Management
Installation Procedure
31
Step 8: Complete Installation
1. Tighten the sealing nut (Torque 3 N
.
m/25 in-lbs) and lock nut (Torque 4 N
.
m/35 in-lbs).
CAUTION: Do not over-tighten. Over-tightening can cause the CAT5 cable to crush and can subsequently damage
the power injector or the unit.
2. Tighten the RJ45 sealing cap.
CAUTION: Be sure you have re-installed the waterproof caps on the serial and Ethernet port connections. It is also good
installation practice to use Butyl weatherproofing tape to seal the caps, as this adds an extra layer of
protection.
Torque 3 N
.
m/25 in-lbs
Torque 4 N
.
m/35 in-lbs