Specifications

Installation and Initialization MP.11 5054-R/2454-R Installation and Management

Installation Procedure

NOTES:

• The Configure System window provides a selectable Country field that automatically provides the allowed

bandwidth and frequencies for the selected country as well as, where applicable, Dynamic Frequency Selection

(DFS) and Transmit Power Control (TPC).

• Non-US installers should not add an antenna system until the Country is selected, the unit is rebooted, and the

proper power level is configured. The output power level of the final channel selected by DFS scan can be

found in the Event Log.

• Be sure to read the Release Notes file on the product CD as it contains software version and driver information

that may not have been available when this document was produced.

• Equipment is to be used with, and powered by, the power injector provided or by a power injector that meets

these requirements:

– UL-Listed/ITE (NWGQ)

– Limited Power Source Output per UL/IEC 60950

– CE-marked

– Approved for Power-over-Ethernet

– Rated output, 48 Vdc/0.42 A

– Pinout follows 802.3af standard for mid-span devices

IMPORTANT:

Before installing and using this product, see Safety and Regulatory Compliance Information on the

product CD.

WARNING:

To ensure proper grounding, use the hole at the bottom point on the back of each unit and the provided

grounding screws to attach a ground wire of at least 10 AWG stranded to each unit. Use proper wire

grounding techniques in accordance with local electric codes.