Specifications

MP.11 5054-R/2454-R Installation and Management
123
7
Monitoring
This chapter describes using the Web interface to obtain detailed information about the settings and performance of the
unit.
Click the Monitor button to access this information.
The following tabs appear in the Monitor section:
• Wireless (see Monitor the Wireless Settings)
•ICMP (see View Number of ICMP Messages)
• Per Station (see View Per Station Statistics)
• Features (see View Features Supported)
• Link Test (see Test Link Quality)
• Interfaces (see Monitor Interfaces)
• IP ARP Table (see View the Mapping of IP and MAC Addresses)
• IP Routes (see View Active IP Routes)
• Learn Table (see View All Detected MAC Addresses (Learn Table))
•RIP (see View RIP Data)
• Radius (see View RADIUS Traffic Information)
• QoS (see View Quality of Service (QoS) Information)
• Temperature (see View Temperature Log)
NOTE: The Radius tab is available on BSUs only. The RIP tab is relevant only in Routing mode.
Help and Exit buttons also appear on each page of the Web interface; click the Help button to access online help; click
the Exit button to exit the application.
For an introduction to the basics of management, see Basic Management.