Installation guide

Tsunami MP.11 Recommended Antennas

PARABOLIC ANTENNAS

24 dBi Directional Parabolic Grid Antenna

General Description

The Tsunami 24 dBi Directional Parabolic Grid Antenna is a broadband antenna for the 2.4 GHz frequency band.

The grid-type antenna allows either horizontal or vertical mounting on an antenna mast with an outside diameter

of up to 51 mm (2 in).

This antenna typically is used in combination with a Subscriber Unit.

Note: The 24 dBi Directional Parabolic Grid Antenna is not allowed in countries that adhere to the ETSI radio

regulations (also France).

In countries that adhere to the FCC regulations, use of this antenna is allowed only when operated with

specific radio channels that can be set on the Tsunami MP.11.

Kit Contents

The 24 dBi Directional Parabolic Grid Antenna comes in two boxes with the following contents

Feed Box:

1 Feed assembly

1 Sub-reflector

1 #6 x 1/2 inch stainless screw

2 Stainless 1/4 x 20 hex nuts

2 Stainless lock washers

2 Stainless carriage bolts

Reflector Box:

2 Reflector halves

2 Stainless U-bolts

2 Mast clamps

1 Mounting ‘L’ shaped bracket

4 Keps nuts (4) #8-32 machine screws

6 Stainless 1/4 x 20 hex nuts

6 Stainless lock washers

2 Stainless carriage bolts

1 Stainless flat plate washer

Note: Prior to installation, or climbing the roof, verify if all parts and components are included. If any part is

missing or appears to be damaged, consult your authorized Proxim Tsunami reseller.