Installation guide

Tsunami MP.11 Recommended Antennas

Mounting 14 dBi Antenna to a Mast

Mounting on a Flat Surface

For mounting the antenna to a flat vertical surface, you must provide a smooth surface for the antenna mount. On

wall surfaces such as brick, block or stucco, use an intermediate surface such as a plywood board or metal plate

between the wall and antenna. The intermediate surface must be of sufficient strength to prevent distortion of the

antenna base when the mounting hardware is tightened.

To mount the antenna proceed as follows:

1. Verify whether you have all the following items:

The 2.4 GHz antenna

(optional) an intermediate plate

4 plugs and screws

4 flat washers

An electric drill

A screwdriver to tighten the screws

2. Note the arrows on the mounting plate; mount the antenna with the arrows pointing up.

3. Attach the antenna using the intermediate plate, metal backing plate and flat washers.

CAUTION! Always use flat washers between the screws and the plastic mounting plate. Avoid over-

tightening nuts and screws to prevent damage to the mounting plate.