Installation Manual

Tsunami Multipoint Version 1.3 Installation Guide
1. Cut 750-00891-00 tubing or Proxim approved equivalent to 1.25" +/- 0.1".
2. Using silicone spray or equivalent lubricant, spray the end of the wire, then slide the tubing onto the
wire, approximately 4" out of the way.
3. Slide the backshell with the ½" (inside diameter) rubber cable seal onto the wire.
4. Crimp the connector pins onto the individual wires using a Positronic crimping tool 9507 (crimping
frame) and 9502-20 (die).
5. Insert the 1.9" (outside diameter) 1/8" wide plastic ring inside the rear of the connector.
6. Insert the crimped pin/wire assemblies in the appropriate holes in the rear of the connector.
7. Attach the backshell to the connector by threading it clockwise onto the connector.
Note: You need a FR19MF1822K0 connector plug (no pins required, housing only) to get a better grip on the
connector. A good grip is required to sufficiently torque the backshell to provide a good seal. When torquing
the backshell, make sure the CAT5 cable can still rotate freely inside the backshell so it does not get broken.
8. Using silicone spray, slide the tubing into the cable seal inside the backshell until it is flush with the
end of the connector.
9. Install the backshell clamp over the tubing and wire.
Table I - Wiring Table II – Cable Length
Pin Pos Color Signal AMP Pin Dash No Length
17
10
orange
white/orange
48VDC+
48VDC-
1
2
-01 25m-.1m
6
5
brown
white/brown
48VDC+
48VDC-
3
4
-02 50m-.1m
12
13
violet
white/violet
Rx+
Rx-
7
8
-03 75m-.1m
1
2
green
white/green
Tx+
Tx-
5
6
Figure 39. BSU Power and Ethernet Cable Connectors
Appendix D. Constructing Power and Ethernet Cables 66
CPN 63179 Issue Date: 01/24/03