Installation Manual

Tsunami Multipoint Version 1.3 Installation Guide
Appendix D. Constructing Power and Ethernet Cables
Subscriber Unit Power and Ethernet Cable
Perform the following steps to construct a Subscriber Unit power and Ethernet cable of the desired length.
CAUTION For best results this cable should be constructed by professional cable
manufacturer or by experienced personnel with proper tools. Contact Proxim
Customer Service or Sales for recommendations for a manufacturer near your
vicinity.
Figure 30. 8-Pin DIN and RJ45 Contact Arrangements
Perform the following steps to construct an interface cable of the desired length.
WARNING! Interface cable length should not exceed 75 m.
Required Materials
The following is a list of the materials required to assemble an interface cable.
▪ Cat 5 UV cable (75 meters maximum).
▪ One each 8-pin DIN male connector with cover (solder type) or one each 8-position DIN male
connector (crimp type).
▪ One each Woodhead weatherproof RJ45 connector.
Appendix D. Constructing Power and Ethernet Cables 62
CPN 63179 Issue Date: 01/24/03