Installation Manual

Tsunami Multipoint Version 1.3 Installation Guide
Subscriber Utility Software
System Requirements
Same as for Base Station Configuration Software (see “System Requirements” for the BSU on page 51).
Installing the Subscriber Utility Software
System requirements for the Subscriber Utility software are the same as for the Base Station
Configuration software.,
To install the utility software:
1. Identify the computer on which you plan to run the Subscriber Utility.
Note: See “System Requirements” for the BSU on page 51 for operating system and hardware requirements.
2. Insert the Tsunami MP CD (provided with the product) into the computer’s CD-ROM drive and open
the CD’s config software folder.
Note: If the computer has Microsoft IIS (Internet Information Services) running, disable or uninstall it before
running the Subscriber Utility.
3. Double-click SUSETUP.HTM or use a Web browser to open the file.
4. Place a checkmark next to the Include VM in download option to install Java Virtual Machine (VM).
Note: You need not add VM if your computer already has a version of VM installed.
5. Click the Start Installer for Windows button to begin the software installation.
6. Follow the on-screen instructions to install the software.
7. Click Done when the installation is finished to close the installer.
8. Launch the Subscriber Utility.
Firmware Downloads
Firmware can be downloaded to the BSU using the local console. Firmware can be downloaded to the SU
either over-the-air or from a local console (by attaching a PC with the Base Station Configuration
Software to the SU).
Proxim recommends you download new code as follows:
1. Download the new code to the SU’s and verify that they re-enter the network.
2. Next, download new code to the BSU.
Appendix B. Installing the Software and Upgrading Firmware 54
CPN 63179 Issue Date: 01/24/03