Installation Manual

Tsunami Multipoint Version 1.3 Installation Guide
Change the Frequency Plan and Operating Frequency
Tsunami Multipoint offers several frequency plans and operating frequencies to provide a means for
overcoming interference. If one part of the 5.8 GHz spectrum is occupied when you deploy the product,
you can select a different frequency plan to bypass the interfering frequency.
To select a frequency plan and operating frequency, specify a frequency plan (4, 5, or 6), then one of the
available frequencies (one of four frequencies for plan 4, one of five frequencies for plan 5, one of six
frequencies for plan 6). Plan 4 is the default frequency plan. Operating frequencies in the 5 and 6 plans
overlap. See “Frequency Plans” on page 57 for details about the available frequency plans and operating
frequencies.
To select a frequency plan, from the BSU console, enter freqPlan<frequency plan> where <frequency
plan> is 4, 5, or 6.
To select an operating frequency, from the BSU console, enter frequency<frequency ID> where
<frequency ID> is:
For plan 4: A, B, C, or D
For plan 5: A, B, C, D, or E
For plan 6: A, B, C, D, E, or F
For example, to change to the 5e plan, enter freqPlan 5; then enter frequency e.
Appendix A. Initial Configuration Settings 50
CPN 63179 Issue Date: 01/24/03