User's Manual Part 2
Table Of Contents
- Chapter 4. System Diagnostics and Operating Tips
- Appendix A. Initial Settings
- Appendix B. Installing the Configuration Software and Upgrading Firmware
- Appendix C. Technical Specifications
- Burst-Rate Limit
- Downlink/Uplink Throughput
- Frequency Plans
- Tx Power
- Antenna
- Receiver Sensitivity
- Maximum Distance Between Base Station and Subscriber Unit
- System
- Standards Compliance and Interfaces
- Configuration and Management
- Power/Environment Safety
- Physical Dimension
- Installation Details
- Optional Accessories
- Appendix D. Constructing Power and Ethernet Cables
- Appendix E. Lightning Protection Recommendations
- Appendix F. Technical Support and Training
Tsunami Multipoint Version 1.3 Installation Guide
Pinout and Wiring Specifications:
Surge Side Equipment Side Application Wire Color
VDC in VDC out 48 VDC White/Orange
RTN in RTN out Ground Orange
VDC in VDC out 48 VDC White/Brown
RTN in RTN out Ground Brown
Tx+ in Tx+ out Tx + Green
Tx- in Tx- out Tx - White/Green
Rx+ in Rx+ out Rx + Violet
Rx- in Rx- out Rx - White/Violet
GND GND Shield, if req. N/A
For additional information, go to www.transtector.com
.
Contact information:
Transtector Systems (208) 762-6069
OEM Division (208) 752-6155 (fax)
10701 Airport Drive oem@transtector.com
Hayden Lake, ID 83858
Appendix E. Lightning Protection Recommendations C-
CPN 63179 Issue Date: 01/24/03
75