User's Manual Part 2
Table Of Contents
- Chapter 4. System Diagnostics and Operating Tips
- Appendix A. Initial Settings
- Appendix B. Installing the Configuration Software and Upgrading Firmware
- Appendix C. Technical Specifications
- Burst-Rate Limit
- Downlink/Uplink Throughput
- Frequency Plans
- Tx Power
- Antenna
- Receiver Sensitivity
- Maximum Distance Between Base Station and Subscriber Unit
- System
- Standards Compliance and Interfaces
- Configuration and Management
- Power/Environment Safety
- Physical Dimension
- Installation Details
- Optional Accessories
- Appendix D. Constructing Power and Ethernet Cables
- Appendix E. Lightning Protection Recommendations
- Appendix F. Technical Support and Training
Tsunami Multipoint Version 1.3 Installation Guide
Wire Size and Preparation
Contacts are available for the wire sizes specified. Prepare the wire for crimping by stripping the
insulation. DO NOT nick, scrape, or cut the stranded or solid wire conductor while stripping the
insulation.
Note: When using twisted pair cable, cut one wire shorter than the other.
Figure 42. Wire Preparation
Tooling
AMP hand crimping tools and applicators are available for applying crimp type contacts. Also, insertion
and extraction tools assist in assembly and repair. See the documentation included with the tool for
more information.
Figure 43. BSU Cable Construction Tools
Appendix D. Constructing Power and Ethernet Cables 68
CPN 63179 Issue Date: 01/24/03