User's Manual Part 2
Table Of Contents
- Chapter 4. System Diagnostics and Operating Tips
- Appendix A. Initial Settings
- Appendix B. Installing the Configuration Software and Upgrading Firmware
- Appendix C. Technical Specifications
- Burst-Rate Limit
- Downlink/Uplink Throughput
- Frequency Plans
- Tx Power
- Antenna
- Receiver Sensitivity
- Maximum Distance Between Base Station and Subscriber Unit
- System
- Standards Compliance and Interfaces
- Configuration and Management
- Power/Environment Safety
- Physical Dimension
- Installation Details
- Optional Accessories
- Appendix D. Constructing Power and Ethernet Cables
- Appendix E. Lightning Protection Recommendations
- Appendix F. Technical Support and Training
Tsunami Multipoint Version 1.3 Installation Guide
About Crimping
Loose piece contacts are designed to be crimped with crimp tooling (hand tools, die assemblies, or
crimping heads), but can be done with normal hand tools. The applicable crimp tooling for the contacts is
described later in this section. Read the documentation included with the crimp tooling for the proper
crimping procedure.
Figure 40. Crimping Styles and Insertion
Figure 41. Indoor Portion of Power and Ethernet Cable
Appendix D. Constructing Power and Ethernet Cables 67
CPN 63179 Issue Date: 01/24/03