User Manual Part 2

Lynx.GX Installation and Management
User Access Security Two level password protection
Performance Management ES, SES, BER, LOS; near and far end
Alarm Log Up to 20,000 entries
Software Updates Download via HTTP over Ethernet
Configuration Management Local end or remote end using internal PPP, via IP address
Advanced features
Spectrum Analyzer – 25 (2 MHz) display points;
RSL Time charting – 5 sample rate selections; downloadable Integral NMS router
Power Requirements
IDU VDC nominal input voltage -48 Vdc or +24 Vdc
IDU DC Input Voltage Range -20 to –60 Vdc or +20 to +60 Vdc
Power Consumption Per Terminal < 70 watts
Power Consumption IDU: < 40 watts; RF Unit: <30 watts
AC Adapter (external) for IDU 130 watts; 50/60 Hz, 110/220 VAC; -48 Vdc, 2.7A
DC Power Connector (IDU) 3-pin barrier strip type, plug-in (+, Gnd, -)
Connector (IDU to RF Unit) TNC female
RF Unit voltage level +42 volts DC
Power delivery to RF Unit DC voltage over coax cable from IDU
Mechanical
IDU Size (w x h x d)
Weight
17.2 x 1.72 x 10.9 inch (1RU) [43.6 x 4.4 x 27.6 cm]
6.5 lbs / 2.9 kg
RF Unit Size (w x h x d)
Weight
14.1 x 1.72 x 10.9 inch (1RU) [35.8 x 4.4 x 27.6 cm]
12.0 lbs / 5.4 kg
Mounting
IDU: EIA rack mount 19-inch rack mount; 23-inch extenders in kit
RF Unit: EIA rack mount 19-inch rack mount; 23-inch extenders in kit
Pole-mountable, 1.5 to 3 inch diameter pole using optional outdoor mounting
plate
Cooling
IDU: 3 each DC fans
RF Unit: Built-in Heatsink, convection cooled in proper mounting configuration
CABLE SPECIFICATIONS
RF Cable to antenna
Cable type Low-loss coaxial: ½” foam, equivalent or better
Cable connector Type-N male
Impedance 50 ohm
IDU-RF Unit interconnection
Cable Type
LMR-240 or equivalent for <100 meters
LMR-400 or equivalent for <300 meters
Cable Connector TNC male
Impedance 50 ohm
DC power +42 VDC
Appendix F. Lynx.GX Specifications 91