User Manual Part 2

Lynx.GX Installation and Management
DETAILED LYNX.GX SPECIFICATIONS
General System Parameters
Operating Frequency 5.8 GHz ISM band
Product Configuration Split box IDU + RF Unit (RFU with outdoor option)
Digital Capacity Up to 16 x T1 (16 x 1.544 Mbps)
Intermediate Frequency 749 MHz, 140 MHz (+/- 2 MHz)
Digital Interface DSX-1 for T1, CEPT-1 for E1
Error Floor <10
-11
Latency (msec)
325 µsec ± 10% plus air latency (speed of light)
Error Correction FEC, Reed-Solomon Decoding
Security
User-programmed 12 character Link ID (48 bits), imbedded and multiplexed into total
digital signal
Regulatory Compliance FCC Part 15.247; IC RSS210
FCC ID / Industry Canada ID HZB –US5358-GX1 / 1856A-U5358GX1
Auxiliary Connections (IDU)
Orderwire (for DTMF Handset)
Connector 2-wire, 6-pin modular jack RJ-11
REN 1.0 B or less
DTMF Tones
Within ± 1.5% of nominal frequency (+0 to 6 dB)
Ringing Voltage +48 AC, typical
Address 100, from 00 to 99
VF (Orderwire Bridge)
Connector 8-pin modular RJ-45 jack (4-wire); bridged to Orderwire RJ-11
Input Level and Output Level 0 dBm
Impedance 600 ohm balanced
Configuration Port
Connector DB-9 DTE (female, 9 pin D sub)
Protocol (serial) EIA-574 (8 bit data, No Parity, 1 Stop Bit)
Data Rate 9.6 kbps
Auxiliary Data Port
Connector 8-pin modular RJ-45 DCE
Protocol (serial) EIA-561 (8 bit Data, No Parity, 1 Stop Bit)
Data Rate 2.4 kbps, 4.8 kbps, 9.6 kbps, 19.2 kbps (selectable)
Alarms Port
Connector DB-9 (female, 9 pin D sub)
Form C Relay (NO, NC) Minor “Summary” Alarm, Major “Out-of-Service” Alarm
External Contact Relay Two, alarm caused by open or close condition set by user
Appendix F. Lynx.GX Specifications 89