Installation Manual

Tsunami Multipoint Version 1.3 Installation Guide
4. Click Save Settings and Install Subscriber Unit to launch the aiming tool.
Figure 22. Aiming Tool in Subscriber Utility
5. Slowly adjust the position of the SU until you have maximized the strength of the radio signal.
º The SU beeps after it has detected a signal from the BSU. The beeps increase in frequency as the
strength of the signal received from the BSU increases.
º The Receive Signal Quality indicator within the Subscriber Utility’s Installation window reports the
strength of the radio signal.
6. Click OK to close the aiming tool.
7. If you have left the Base Station Configuration Software running on the computer connected to the
BSU, a notification is displayed once the SU has successfully joined the network (this is known as a
“net entry” notification).
Displaying Link Status Information
The Status window displays the current information at the SU, as well as information about the link
between the BSU and the local SU. The information is described following the figure. To display the
Status window, launch the Subscriber Utility and then select the Status tab.
The Status window is displayed, as shown in the following figure.
Chapter 3. Deploying the Subscriber Unit (SU) 36
CPN 63179 Issue Date: 01/24/03