Installation Manual

Tsunami Multipoint Version 1.3 Installation Guide
8. Connect the other end of the Cat 5 cable to the SU’s power supply. Be sure the Tsunami Multipoint
Subscriber Unit connector is properly “contacted” or the unit may fail; you should hear a “click” when
installing the cable connector to its chassis. The proper way to install is as follows:
A) Insert the O-ring into the SU’s Power and Ethernet port.
B) Loosen the rear nut on the end of connector cable.
C) Pull the RJ-45 head out a few millimeters from the connector body.
D) Push the RJ-45 head into the chassis connector and listen for a solid “click.”
E) Push the water seal cap back and tighten the cap.
F) Tighten the rear nut.
Note: While not necessary, it is advisable to implement additional external weatherproofing, such as
weatherproof tape and silicon at the inside base of the threaded part of the connector.
9. Connect one end of a Cat 5 cable to the SU’s power supply’s RJ-45 port and the other end to a switch
or directly to the computer onto which you installed the Subscriber Utility.
10. Plug the SU’s power supply into an electrical outlet.
Installing the Subscriber Utility Software
The subscriber utility is used in the antenna pointing process and must be installed to finish the SU
installation.
1. Identify the computer on which you plan to run the Subscriber Utility.
Note: See “System Requirements for Base Station Configuration Software” on page 51 for operating system
and hardware requirements.
2. Insert the Tsunami MP CD (provided with the product) into the computer’s CD-ROM drive and open
the CD’s config software folder.
Note: If the computer has Microsoft IIS (Internet Information Services) running, disable or uninstall it before
running the Subscriber Utility.
3. Double-click SUSETUP.HTM or use a Web browser to open the file.
4. Place a checkmark next to the Include VM in download option to install Java Virtual Machine (VM).
Note: You need not add VM if your computer already has a version of VM installed.
5. Click the Start Installer for Windows button to begin the software installation.
Chapter 3. Deploying the Subscriber Unit (SU) 34
CPN 63179 Issue Date: 01/24/03