Installation Manual

Tsunami Multipoint Version 1.3 Installation Guide
4. Insert the two #10-32 screws in the sides of the mounting clamp housing/pole clamp assembly and
loosely attach the two #10-32 nuts.
Figure 19. Mounted SU
5. After you aim the SU (see “Aiming the SU” on page 35), tighten the two #10-32 screws and nuts to
secure the SU in position.
6. Insert the O-ring into the SU’s Power and Ethernet port.
7. Connect one end of the supplied Cat 5 cable to the SU’s Power & Ethernet port and screw on the
outer ring to secure the cable in place.
Figure 20. SU’s Power and Ethernet Connector and Grounding Screw
Note: To ensure proper grounding, use the hole on the back of each SU and the provided grounding screws to
attach a ground wire to each radio. Use wire grounding techniques in accordance with your local electrical
codes.
Chapter 3. Deploying the Subscriber Unit (SU) 33
CPN 63179 Issue Date: 01/24/03