User's Manual

INSTALLATION AND MAINTENANCE MANUAL
Tsunami FAMILY
SPREAD SPECTRUM RADIOS
SEPTEMBER 1999
SECTION 2: PRODUCT DESCRIPTION PAGE 2-21
SW2
Ethernet
Bridge
Address
These switch segments allow the user to select a unique address for a
particular link between two LANs. This feature provides a level of security to
prevent another radio in the communication path to pick up the transmitted data
unless it is set to the exact same address (1 out of 256 unique addresses). Be
sure each point-to-point link is set to the same address. If not, the radio will
invoke the MUTE function.
SW3
Spreading
Code
This set of switch segments allow the user to select the spreading code for the
spread spectrum signal. Both ends of a radio system must be set to the same
code. Users may wish to change codes for radios that are nearby other similar
radios to aid in interference rejection. (see Section 3.12.3)
Channel
Selection
This set of switch segments programs the radio to match the specific RF
channel corresponding to the RF filter set which has been installed. (see Section
3.12.1)
Address
There are two rotary switches which determine the radio's address (01 to 99).
This address is used for Orderwire signaling (dial a particular radio in the
network).
Refer to Appendix B for Switch Settings