mini PCI High Power MIMO IEEE 802.
NOTICE: The information in this document has been carefully reviewed and is believed to be accurate. Nonetheless, this document is subject to change without notice, and Proxim Wireless Corporation (Proxim) assumes no responsibility for any inaccuracies that may be contained in this document and makes no commitment to update or to keep current the contained information, or to notify a person or organization of any updates. Proxim reserves the right to attempt to supply the best product possible.
INTRODUCTION The Proxim PROXMB82 miniPCI module implements an IEEE 802.11a/b/g/n wireless LAN (WLAN) with DFS Master function. MIMO operation is implemented using three transmit and three receive chains per the 802.11n standard. The device will be marketed under brand name: PROXMB and model: PROXMB82. This module may be installed in PC and host processor systems using approved external antennas. The module may be configured for 2.
CONFIGURATION This section provide procedures for connecting and configuring the AP. Configuration can be performed either from a web browser accessing the build-in web server, or by entering commands using the command line interface (CLI). For detailed information on using the server refer to “AP Web Server and for using CLI, refer to detailed operational guide provided by Atheros for the chipset. AP Initial Configuration Configure the AP for its Service Set Identifier (SSID) unique to the application.
To configure a single SSID to have more then one AP in a single SSID, specify a unique System Name for each AP within that single SSID. Note that range of available channels will be automatically determined by factory settings. Note that the radio channel is specified using the IEEE 802.11 a standard. For example, channel 48 is the equivalent of 5.240 GHz. The channel number is derived as: Channel Frequency (in MHz) – 5000 MHz Channel Number = 5MHz 1 Click Update to commit the changes.
FCC Requirements for Operation in the United States This device is restricted to indoor use only due to its operation in 5150 to 5250 MHz and 5470 to 5725 MHz frequency ranges in accordance with latest FCC regulations. Host systems using Porxim Firmware with this 802.11 a/b/g/n 3x3 MIMO nimiPCI module to be sold in the United States do not have country code settings and are factory configured to only operate on the channels allowed by the FCC. Master devices with a US SKU that contain the 802.
mation: TDWR Locatioon Inform
FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. IMPORTANT NOTE: This module is intended for OEM integrator only and limited to host with brand: Tsunami/ORiNOCO and model list.
IC Statement This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil numérique de la classe B est conforme á la norme NMB-003 du Canada. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
The maximum antenna gain permitted (for devices in the band 5725-5825 MHz) to comply with the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate, as stated in section A9.2(3). IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Mo odel Iist:
