User's Manual

Advanced Configuration
Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 96
• Max Messages in Burst: 16
• Entry Status: Enable
d. Click Add. The UL-Management SF is added to the QoS SFC List.
NOTE: The input and output bandwidth limits set on the End Point A or on the End Point B are used for limiting
aggregate bandwidth used by End Point B. These limits override any limit imposed by MIR in the SFC. Therefore,
these limits should be set to at least 1000 kbps (MIR values in UL-Management and DL-Management SFCs).
Step 3: Configure QoS Classes
Finally, the DL-Management SFC and UL-Management SFCs created in Step 2 must be added to each QoS Class used by the
Quick Bridge network. Additionally, within the QoS class, these SFC must have the three PIRs mentioned in Step 1 associated
with them.
1. Add SFCs to QoS Class.
a. Click ADVANCED CONFIGURATION > QoS > Class list.
b. Click Details corresponding to the first class (Unlimited Best Effort) you wish to modify.
c. Under the QoS Class Service Flow, click Add.
d. Configure the following parameters, and click Add. This adds the New SFC & PIR relation to the QoS Class.
• Service Flow Name: DL-Management
• PIR Rule Name: ARP
• PIR Priority: 63
• Entry Status: Enable.
e. Again click Add under the QoS Class Service Flow Details.
f. Configure the following parameters and click Add. This adds the New SFC & PIR relation to the QoS Class.
• Service Flow Name: UL-Management
• PIR Rule Name: ARP
• PIR Priority: 63
• Entry Status: Enable
2. Add PIRs to SFCs within the QoS Class.
a. Click ADVANCED CONFIGURATION > QoS > Class list.
b. Click Details corresponding to the first class (Unlimited Best Effort) you wish to modify.
c. Under the QoS Class Service Flow Details heading, click Details corresponding to the DL-Management Service
Flow.
d. Under the QoS Class PIR Details heading, click Add.
e. Add the Management Station DST IP PIR to this Service Flow by configuring the following parameters:
• PIR Rule Name: Management Station DST IP
• PIR Priority: 63
• Entry Status: Enable
f. Click Add. This PIR is added to the first Qos Class (Unlimited Best Effort) Service Flow’s (DL-Management) list.
g. Add the Management Station SRC IP PIR to this Service Flow by configuring the following parameters:
• PIR Rule Name: Management Station SRC IP
• PIR Priority: 63
• Entry Status: Enable
h. Return to the Class List screen and repeat steps 2 - 7 for the UL-Management Service Flow in this class.