User's Manual

Advanced Configuration
Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 95
c. Click Add that corresponds to Source IP Address Entries. This displays a screen for referring the Management
Station’s IP Address. New Entry Table displays all the IP Address Entries of the PIR List. Select the option button
corresponding to the Management Station and then click Add. This adds the IP Address of the Management
Station to the Existing Entries. Click Back and the new entry appears in the Source IP Address Entries Table.
5. Add PIR Rule for Destination IP Address.
a. Click Add. This displays a screen for adding the New PIR Rule. Enter the PIR Rule Name as “Management Station
DST IP”, Entry status as Enable and then click Add. This adds the new PIR rule in the PIR List. By default, no
classification rules are applied.
b. Click ADVANCED CONFIGURATION > QoS > PIR list. Click Details corresponding to the “Management Station
DST IP” PIR rule. This displays the classification rule details for this particular rule.
c. Click Add corresponding to Destination IP Address Entries. This displays a screen for referring the Management
Station’s IP Address. New Entry Table displays all the Entries of the IP Address Entries of the PIR List. Select the
option button corresponding to the Management Station and click Add. This adds the IP Address of the
Management Station to the Existing Entries. Click Back and the new entry appears in the Destination IP Address
Entries Table.
Step 2: Add Service Flow Classes
To handle management traffic, the system needs two Service Flow Classes: one for uplink traffic and one for downlink traffic.
1. Configure the Downlink Service Flow.
a. Click ADVANCED CONFIGURATION > QoS > SFC list.
b. Click Add.
c. Enter the following parameters:
• Service Flow Name: DL-Management
• Scheduler Type: RtPS
• Traffic Direction: Downlink
• MIR: 1000
• CIR: 1000
• Max Latency: 20
• Tolerable Jitter: 10
• Priority: 7
• Max Messages in Burst: 16
• Entry Status: Enable
d. Click Add. The DL-Management Service Flow is added to the QoS SFC List.
2. Configure the Uplink Service Flow.
a. Click ADVANCED CONFIGURATION > QoS > SFC list.
b. Click Add.
c. Enter the following parameters:
• Service Flow Name: UL-Management
• Scheduler Type: RtPS
• Traffic Direction: Uplink
• MIR: 1000
• CIR: 1000
• Max Latency: 20
• T
olerable Jitter: 10
• Priority: 7