User's Manual

Advanced Configuration
Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 66
4.5.1.1 Creating a New Security Profile
To create a new security profile
1. Click ADVANCED CONFIGURATION > Security > Wireless Security.
2. Click Add in the Wireless Security Configuration screen to create a new entry. The Wireless Security Add Row screen is
displayed as shown below.
Figure 4-13 Creating a New Security Profile
3. Enter the appropriate parameters in the Wireless Security Add Row screen. See the following table for information on
the parameters and their descriptions.
4. Click Add.
Field Description
Profile Name Enter the security profile name.
Encryption Type Select an option from None or AES-CCM for the Encryption Type.
1. None - If this option is selected, no encryption will be applied to the wireless link frames.
2. AES-CCM - This option represents CCM Protocol with AES Cipher restricted to 128 bits.
• Key 1 : Enter 16 ASCII Characters or 32 Hex Digits.
Entry status Select Enable/Disable to enable or disable the status of the security profile.
Network Secret Enter the WORP Protocol Secret Key used for authenticating the End Point B with End Point A.
NOTE: End Point A and End Point B must have same Network Secret.