User's Manual
Table Of Contents
- Preface
- Overview
- Installation and Initialization
- Basic Configuration
- Advanced Configuration
- 4.1 System Configuration
- 4.2 Network Configuration
- 4.3 Ethernet Properties Configuration
- 4.4 Wireless Configuration
- 4.5 Security Configuration
- 4.6 Quality of Service (QoS) Configuration
- 4.7 VLAN Configuration (Bridge Mode only)
- 4.8 Filtering Configuration (Bridge Only)
- 4.9 DHCP Configuration
- 4.10 IGMP Snooping (Bridge Mode only)
- 4.11 Routing Features Configuration
- System Management
- Monitoring the System
- Procedures
- 7.1 TFTP Server Setup
- 7.2 Web Interface Firmware Download
- 7.3 Configuration Backup
- 7.4 Configuration Restore
- 7.5 Text Based Configuration (TBC) File Management
- 7.6 Soft Reset to Factory Default
- 7.7 Hard Reset to Factory Default
- 7.8 Forced Reload
- 7.9 Upgrade a New Firmware Using ScanTool in Bootloader Mode
- 7.10 Download a New Firmware Using CLI from Bootloader
- Troubleshooting
- 8.1 PoE Injector
- 8.2 Connectivity Issues
- 8.3 Communication Issues
- 8.4 Setup and Configuration Issues
- 8.4.1 Lost Password
- 8.4.2 The QB-8100 Responds Slowly
- 8.4.3 Device Has Incorrect IP Address
- 8.4.4 HTTP Interface Does Not Work
- 8.4.5 Telnet CLI Does Not Work
- 8.4.6 TFTP Server Does Not Work
- 8.4.7 Setting IP Address using Serial Port
- 8.4.8 RADIUS Authentication Server
- 8.4.9 TFTP Server
- 8.4.10 Recovery Procedures
- 8.4.11 Soft Reset to Factory Defaults
- 8.4.12 Hard Reset to Factory Defaults
- 8.4.13 Forced Reload
- 8.4.14 VLAN Operation Issues
- 8.4.15 Changes Do Not Take Effect
- 8.4.16 Link Problems
- 8.4.17 General Check
- 8.4.18 Statistics Check
- 8.4.19 Analyzing the Spectrum
- Frequency Domains and Channels
- Boot Loader CLI and ScanTool
- Technical Specifications
- Part Numbers
- Regulatory Approval and Frequency Domains
- Integrated Dual Polarized Panel Antenna Specifications
- Radio and Transmission Specifications
- OFDM Modulation Rates
- Wireless Protocol
- Interfaces
- Transmit Power Settings
- Receive Sensitivity
- Latency
- Latency
- Management
- Power Supply
- LEDs
- Software Features
- Hardware Specifications
- Physical and Environmental Specifications
- MTBF and Warranty
- Lightning Protection
- Statement of Warranty
- Technical Services and Support
Technical Specifications
Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 210
OFDM Modulation Rates
Wireless Protocol
Interfaces
Modulation Data Rate (Mbps)
5 MHz Channel
Bandwidth (for
Full GI-800ns)
10 MHz Channel
Bandwidth (for
Full GI-800ns)
20 MHz Channel
Bandwidth (for
Full GI-800ns)
40 MHz Channel Bandwidth
Short GI-400ns Full GI-800ns
Single
Stream
Dual
Stream
Single
Stream
Dual
Stream
Single
Stream
Dual
Stream
Single
Stream
Dual
Stream
Single
Stream
Dual
Stream
64QAM 5/6 16.2 32.5 32.5 65 65 130 150 300 135 270
64QAM 3/4 14.6 29.3 29.3 58.5 58.5 117 135 270 121.5 243
64QAM 2/3 13 26 26 52 52 104 120 240 108 216
16QAM 3/4 9.7 19.5 19.5 39 39 78 90 180 81 162
16QAM 1/2 6.5 13 13 26 26 52 60 120 54 108
QPSK 3/4 4.9 9.7 9.7 19.5 19.5 39 45 90 40.5 81
QPSK 1/2 3.2 6.5 6.5 13 13 26 30 60 27 54
BPSK 1/2 1.6 3.3 3.3 6.5 6.5 13 15 30 13.5 27
Category Specification
Wireless Protocol WORP (Wireless Outdoor Router Protocol)
Category Specification
Wired Ethernet One auto MDI-X RJ45 100 Mbps Ethernet Port
Serial Connector RS 232 Serial (RJ11 to DB9)