User's Manual
Table Of Contents
- Preface
- Overview
- Installation and Initialization
- Basic Configuration
- Advanced Configuration
- 4.1 System Configuration
- 4.2 Network Configuration
- 4.3 Ethernet Properties Configuration
- 4.4 Wireless Configuration
- 4.5 Security Configuration
- 4.6 Quality of Service (QoS) Configuration
- 4.7 VLAN Configuration (Bridge Mode only)
- 4.8 Filtering Configuration (Bridge Only)
- 4.9 DHCP Configuration
- 4.10 IGMP Snooping (Bridge Mode only)
- 4.11 Routing Features Configuration
- System Management
- Monitoring the System
- Procedures
- 7.1 TFTP Server Setup
- 7.2 Web Interface Firmware Download
- 7.3 Configuration Backup
- 7.4 Configuration Restore
- 7.5 Text Based Configuration (TBC) File Management
- 7.6 Soft Reset to Factory Default
- 7.7 Hard Reset to Factory Default
- 7.8 Forced Reload
- 7.9 Upgrade a New Firmware Using ScanTool in Bootloader Mode
- 7.10 Download a New Firmware Using CLI from Bootloader
- Troubleshooting
- 8.1 PoE Injector
- 8.2 Connectivity Issues
- 8.3 Communication Issues
- 8.4 Setup and Configuration Issues
- 8.4.1 Lost Password
- 8.4.2 The QB-8100 Responds Slowly
- 8.4.3 Device Has Incorrect IP Address
- 8.4.4 HTTP Interface Does Not Work
- 8.4.5 Telnet CLI Does Not Work
- 8.4.6 TFTP Server Does Not Work
- 8.4.7 Setting IP Address using Serial Port
- 8.4.8 RADIUS Authentication Server
- 8.4.9 TFTP Server
- 8.4.10 Recovery Procedures
- 8.4.11 Soft Reset to Factory Defaults
- 8.4.12 Hard Reset to Factory Defaults
- 8.4.13 Forced Reload
- 8.4.14 VLAN Operation Issues
- 8.4.15 Changes Do Not Take Effect
- 8.4.16 Link Problems
- 8.4.17 General Check
- 8.4.18 Statistics Check
- 8.4.19 Analyzing the Spectrum
- Frequency Domains and Channels
- Boot Loader CLI and ScanTool
- Technical Specifications
- Part Numbers
- Regulatory Approval and Frequency Domains
- Integrated Dual Polarized Panel Antenna Specifications
- Radio and Transmission Specifications
- OFDM Modulation Rates
- Wireless Protocol
- Interfaces
- Transmit Power Settings
- Receive Sensitivity
- Latency
- Latency
- Management
- Power Supply
- LEDs
- Software Features
- Hardware Specifications
- Physical and Environmental Specifications
- MTBF and Warranty
- Lightning Protection
- Statement of Warranty
- Technical Services and Support
Technical Specifications
Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 208
Regulatory Approval and Frequency Domains
• Safety Standards: UL 60950, CAN/CSA-C22.2 No. 60950, IEC 60950, EN 60950
• Regulatory Certifications: FCC, IC and ETSI
5 GHz Channels/Frequencies
Region/
Country
Frequency
Domain
Frequency
Band
(Start Center
Frequency ~
End Center
Frequency in
MHz)
No. of Channels
5 MHz 10 MHz 20 MHz 40 PLUS
MHz
40 MINUS
MHz
North
America
United States 5 GHz 5260 ~ 5320
5500 ~ 5700
5745 ~ 5825
Not
Supported
Not
Supported
Up to 71 Up to 67 Up to 67
United States 5.8
GHz
5745 ~ 5825 Not
Supported
Not
Supported
Up to 17 Up to 13 Up to 13
United States2 (5.3,
5.8 GHz)
5260 ~ 5320
5745 ~ 5825
Not
Supported
Not
Supported
Up to 30 Up to 26 Up to 26
Canada 5 GHz 5255 ~ 5325
5495 ~ 5585
5655 ~ 5705
Up to 45 Up to 39 Up to 39 Up to 35 Up to 35
Canada 5.8 GHz 5735 ~ 5855 Upto 25 Up to 25 Up to 23 Up to 19 Up to 19
EU
Countries
Eroupe 5.8 GHz 5.740 ~ 5.865 Up to 7 Up to 3 Up to 3
Europe 5.4 GHz 5500 ~ 5700 Not
Supported
Up to 26 Up to 26 Up to 22 Up to 22
Europe 5.8 GHz 5735 ~ 5870 Not
Supported
Up to 28 Up to 25 Up to 21 Up to 21
Russia 5 GHz 5155 ~ 6075 Up to 185 Up to 185 Up to 183 Up to 179 Up to 179
APAC Taiwan 5 GHz 5495 ~ 5810 Up to 58 Up to 54 Up to 54 Up to 50 Up to 50
India 5.8 GHz 5830 ~ 5870 Up to 9 Up to 9 Up to 7 Up to 3 Up to 3
World World 5 GHz 5155 ~ 6075 Up to 185 Up to 185 Up to 183 Up to 179 Up to 179
World 4.9 GHz 4945 ~ 4985 Up to 63 Up to 63 Up to 43 Up to 3 Up to 3
World 5.9 GHz 5880 ~ 5920 Up to 9 Up to 9 Up to 7 Up to 3 Up to 3
United States 5 GHz 5260 ~ 5825 Not
Supported
Not
Supported
Up to 71 Up to 67 Up to 67
UK 5.8 GHz 5735 ~ 5835 Not
Supported
Up to 12 Up to 11 Up to 8 Up to 8