User's Manual

Monitoring the System
Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 156
6.2.3 End Point A Link Statistics (End Point B Only)
WORP End Point A Link Statistics provides information related to End Point A currently connected to the End Point B.
Figure 6-5 WORP End Point A Link Statistics
Click Refresh, to get the updated or latest End Point A Link Statistics.
6.2.4 QoS Statistics (End Point A Only)
To view the QoS Statistics, click MONITOR > WORP Statistics > Interface 1 > QoS Statistics. This page displays the
Provisioned and Active Bandwidth details on End Point A for the registered End Point B.
Remote Antenna Port Info Refers to the status of the remote antenna port of the
End Point B. The status of the remote antenna port is
shown by three different legends. For more
information on the legends, refer to Local Antenna
Port Info.
Remote Signal (dBm) Signal level with which the End Point B receives
wireless frames from the End Point A.
Remote Noise (dBm) Refers to the noise level with which the End Point B
receives wireless frames from the End Point A.
Remote SNR (dB) Refers to the SNR measured by the receiver at the far
end and is based on the Remote Signal and Remote
Noise.
MIMO Chain Balance Refers to the signal balance between minimum 2 Rx
chains. If the signal balance between two antennas is
greater than 5 dB, then, it is recommended to adjust
the antennas so that MIMO Chain Balance becomes
Balanced or switch to Longer Range Data Stream
settings for reliable wireless link.
NOTE: This field is applicable only for Higher
Throughput data streams.
Field Description