User's Manual

System Management
Tsunami QB-8100 Series (100 Mbps/5 Mbps Models) Installation and Management Guide 140
5.3.3.1 SNMPv3 Configuration
Figure 5-14 SNMPv3
Read Password This parameter represents the read only community name used in
SNMP Protocol. It is sent along with each SNMP GET / WALK /
GETNEXT / GETBULK request to allow or deny access to the
device. This password should be same as read password set at
the NMS or MIB browser. The default password is “public” and
range of this parameter must be between 6-32 characters.
Read/Write Password This parameter represents the read-write community name used
in SNMP Protocol. It is sent along with each SNMP GET / WALK /
GETNEXT / SET request to allow or deny access to the device. This
password should be same as read-write password set at the NMS
or MIB browser. The default password is “public” and range of
this parameter must be between 6-32 characters.