User's Manual

ORiNOCO Wireless Client User Guide
Appendix B Warranty and Regulatory Information 62
return the product to Proxim after obtaining an RMA (Return Merchandise Authorization) number.
The product must be returned in its original packaging. The RMA number should be clearly
marked on the outside of the box. Proxim cannot be held responsible for any product returned
without an RMA number, and no product will be accepted without an RMA number.
B-2 Regulatory Information
B-2-1 USA – Federal Communication Commission (FCC)
FCC Class B Statement
This device complies with Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC RF Safety Requirement
The radiated output power is far below the FCC radio frequency exposure limits.
(1) Shielded cables, if any, must be used in order to comply with the emission limits.
(2) Any change or modification not expressly approved by the grantee of the equipment
authorized could void the user authority to operate the equipment.
B-2-1 FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
u Reorient or relocate the receiving antenna.
u Increase the separation between the equipment and the receiver.