User guide

Installation and Initialization AP-4000MR User Guide

Hardware Installation

Step 6: Plug in the Cables

1. Plug one end of the CAT5 cable (A) into the RJ45 jack of the unit (B).

2. Connect the free end of the CAT5 cable to the “Data and Power Out” port on the power injector.

3. To connect the unit through a hub or a switch to a PC, connect a straight-through Ethernet cable between the

network interface card in the PC and the hub, and between the hub and the RJ45 “Data In” port on the PoE adapter.

To connect the unit directly to a PC, connect a cross-over Ethernet cable between the network interface card in the

PC and the RJ45 “Data In” port on the power injector.