User guide

Installation and Initialization AP-4000MR User Guide
Hardware Installation
27
Step 4: Assemble Mounting Hardware
1. Attach the mounting plate (A) using the provided screws and washers (Torque 9 N
.
m/75 in-lbs).
2. Attach the extension arm (B) to mounting piece (A) with the screw, nut, and washers provided, as shown below.
3. Attach the mounting bracket (C) to extension arm (B) with the screw, nut, and washers provided.
4. Tighten assembly (Torque 15 N
.
m/130 in-lbs).
The following figure shows the full assembly attached to the unit.
A
Torque 9 N
.
m/75 in-lbs
B
A
B
C
Torque 15 N
.
m/130 in-lbs