User guide

Command Line Interface (CLI) AP-4000MR User Guide
Configuring the AP using CLI commands
212
[Device-Name]>set dcsthreshold <value 1-10>
The values for the DCS Threshold range from 1 to 10. The default value is 5.
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Shutdown/Resume Wireless Service
[Device-Name]>set wif <index> wssstatus <1 (resume)/2 (shutdown)>
Set Load Balancing Maximum Number of Clients
[Device-Name]>set wif <index> lbmaxclients <1–63>
Set the Multicast Rate (802.11a)
[Device-Name]>set wif 3 multrate <6, 12, 24
(Mbits/sec)>
Set the Multicast Rate (802.11b/g)
[Device-Name]>set wif 4 multrate <1, 2, 5.5, 11
(Mbits/sec)>
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif <index> supermode <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif <index> turbo <enable/disable>
NOTE: Super mode must be enabled on the interface before Turbo mode can be enabled.
NOTE: Turbo mode and Mesh mode (either Mesh AP or Mesh Portal) can not be enabled on the same interface
simultaneously.
Set the Distance Between APs
[Device-Name]>set wif <index> distaps <1–5> (see below)
[Device-Name]>reboot 0
Value Distance Between APs
1 Large
2Medium
3Small
4Mini
5Micro