Installation Guide

Technical Specifications
Edge
TM
v2 - Hardware Installation Guide 22
Transmit Power Specifications (5.150 - 5.925) GHz
Products Stream MCS
Index
Modulation
Type
Coding
Rate
Tx Power* (dBm)
VHT5
(5.15-5.925
GHz)
VHT10
(5.15-5.925
GHz)
VHT20
(5.15-5.925
GHz)
VHT40
(5.15- 5.925
GHz)
VHT80
(5.15- 5.925
GHz)
MP-1035-CPE
MP-1015-BS3
MP-1025-BS3
MP-1045-BS3
MP-1055-BS3
Single
stream
(or)
Dual
Stream
(or)
Quad
Stream
MCS 0
BPSK
1/2
20 21 21 20 18
MCS 1
QPSK
1/2
20 21 21 20 18
MCS 2
QPSK
3/4
20 20 20 19 18
MCS 3
16QAM
1/2
19 19 20 19 18
MCS 4
16QAM
3/4
19 19 19 18 18
MCS 5
64QAM
2/3
18 18 19 18 17
MCS 6
64QAM
3/4
18 18 17 17 17
MCS 7
64QAM
5/6
17 17 17 16 16
MCS 8
256-QAM
3/4
NA NA 16 15 15
MCS 9 256-QAM 5/6 NA NA NA 15 14
Note:
• 5 and 10 MHz channel is only available for Edge MP-1045-BS3 and Edge MP-1055-BS3
• Tx Power value is given per RF chain
* in MIMO 2x2:2 mode, aggregate Tx power is 3 dB higher
* in MIMO 4x4:4 mode, aggregate Tx power is 6 dB higher
• Transmit Power Control (TPC): 0 – 21 dB, in 1 dB steps
* Attenuation is linear down to 3 dBm Tx power. Below 3 dBm, any extra dB attenuation result in less than 1 dB Tx power reduction.
• Total EIRP must be calculated based on the antenna gain
• Tolerance = +/- 2 dB
* Tx Power indicates the power at the radio ports.
* In case of integrated devices, the Tx Power at the antenna ports is 1 dB higher than the above tabulated values.
• In the FCC United States 5.8 GHz band edge frequencies, the Maximum Tx Power of the radio will be restricted based on the FCC Certification
and Antenna Type used. For details refer the Antenna Installation and Recommendation Guide.