Installation Guide

Technical Specifications
Edge
TM
v2 - Hardware Installation Guide 21
Wireless Protocol
Interfaces
Transmit Power Specifications (4.900 - 5.000) GHz
Category Specification
Wireless Protocol WORP
®
(Wireless Outdoor Router Protocol)
Products Category Specification
MP-1035-CPE
MP-1015-BS3
MP-1025-BS3
MP-1045-BS3
MP-1055-BS3
Wired Ethernet Auto MDI-X, auto configuration and fixed
speed/duplex configurations
One auto MDI-X RJ45 Gigabit Ethernet Port
with PoE IN and Data
Products Stream MCS
Index
Modulation
Type
Coding
Rate
Tx Power* (dBm)
VHT5
(4.900-5.000 GHz)
VHT10
(4.900-5.000 GHz)
VHT20
(4.900-5.000 GHz)
MP-1045-BS3
MP-1055-BS3
Single
stream
(or)
Dual
Stream
MCS 0
BPSK
1/2
21 21 21
MCS 1
QPSK
1/2
21 21 21
MCS 2
QPSK
3/4
20 20 20
MCS 3
16QAM
1/2
19 19 20
MCS 4
16QAM
3/4
19 19 19
MCS 5
64QAM
2/3
18 18 19
MCS 6
64QAM
3/4
18 18 17
MCS 7
64QAM
5/6
17 17 17
MCS 8
256-QAM
3/4
NA NA 16
MCS 9
256-QAM
5/6
NA NA NA
Note:
• 4.9 GHz frequency band is only available for Edge MP-1045-BS3 and Edge MP-1055-BS3
• Tx Power value is given per RF chain
* in MIMO 2x2:2 mode, aggregate Tx power is 3 dB higher
• Transmit Power Control (TPC): 0 – 21 dB, in 1 dB steps
*Attenuation is linear down to 3 dBm Tx power. Below 3 dBm, any extra dB attenuation result in less than 1 dB Tx power reduction.
• Total EIRP must be calculated based on the antenna gain
• Tolerance = +/- 2 dB
*Tx Power indicates the power at the radio ports.
*In case of integrated devices, the Tx Power at the antenna ports is 1 dB higher than the above tabulated values.