Installation Guide

Device Installation

Edge

v2 - Hardware Installation Guide 14

Figure 4-3 Pole Mounting (Edge 1015 and 1025)

1. To pole mount the device to a 1 to 2.5 inch diameter pole, insert the two Hose Clamps through the hose clamp slits at

the bottom of the Device. See Figure 4-4.

2. Place the device against the pole and tighten the hose clamps to the pole.

Figure 4-4 Pole Mounting (Edge 1035, 1045 and 1055)

Step 8: Plug in the Cables

1. Plug one end of the straight-through Cat5e cable into the Ethernet Port of the device by following the procedure

explained under Step 5: Weatherproofing RJ45 Connection. Connect the other end of the cable into the OUT / POE

port on the PoE Injector.