User Guide

MP/QB-10xx Series - Regulatory Information
Edge
TM
Multipoint and Quickbridge - Safety and Regulatory Guide 9
1.3.1 IC Radiation Exposure Statement
This device complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. The device should
be installed and operated with a minimum distance of 50cm between the antenna and the user. Under such configuration,
the IC RSS-102 radiation exposure limits set forth for an population/uncontrolled environment can be satisfied. Minimum
distance should be increased if antenna with more than 16 dBi is used. Minimum distance can reach up to 300 cm for high
gain (34 dBi) parabolic dish.
Déclaration d'exposition aux radiations
Cet équipement est conforme aux limites d'exposition aux rayonnements IC RSS-102 établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 50 cm de distance entre la source de rayonnement
et votre corps. Dans ces conditions, les limites d'exposition aux rayonnements IC RSS-102 établies pour un environnement
non contrôlé peuvent être satisfaites. La distance minimum doit etre augmentée si une antenne avec un gain de plus de 16
dBi est utilisée. Cette distance minimum peut atteindre 300 cm pour une antenne parabolique de haut gain (34 dBi).
1.4 European (ETSI) Compliance
The Edge devices comply with the Low Voltage Directive (LVD) (2014/35/EU) and Radio Equipment Directive (2014/53/EU).
Compliance with these directives implies conformity to harmonized European standards (European Norms).
1.4.1 Countries of Operation and Conditions of Use
The devices may be used in the following EU and EFTA countries: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic,
Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta,
Netherlands, Poland, Portugal, Romania, Slovak Republic, Slovenia, Spain, Sweden and the United Kingdom.
The professional installer must use the configuration utility provided with the device to ensure that EIRP and the channels of
operation are in conformance with the spectrum usage rules for EU and EFTA countries as described below.
1.4.2 5 GHz Operation
The installer must use the configuration utility provided with the device to ensure the channels of operation are in
conformance with the spectrum usage rules.
The device employs a radar detection feature required for European Community and EFTA country operation in the 5 GHz
band. This feature is automatically enabled when the country of operation is correctly configured for any European
Community or EFTA country. The presence of nearby radar operation may result in temporary interruption of operation of this
device. The radar detection feature will automatically restart operation on a channel free of radar.
1.4.3 Transmit Power Control (TPC) for 5 GHz operation
It is recommended not to disable ATPC on the device. However, if you wish to manually set TPC level, use professional installer
services to ensure TPC level is set properly and complies with European regulatory requirements.
NOTE:
The TPC procedure should be repeated when relocating the wireless device within the current wireless network or to a
wireless network in a new location.