Installation Guide

Device Installation

Edge

Multipoint and Quickbridge - Hardware Installation Guide 14

Figure 4-3 Pole Mounting (MP-1015 & MP-1025)

1. To pole mount the device, insert the two Hose Clamps through the hose clamp slits at the bottom of the Device. See

Figure 5.

2. Place the device against the pole and tighten the hose clamps to the pole.

Figure 4-4 Pole Mounting (MP-1035)

Step 8: Plug in the Cables

1. Plug one end of the straight-through Cat5e cable into the Ethernet Port of the device by following the procedure

explained under Step 5: Weatherproofing RJ45 Connection. Connect the other end of the cable into the OUT / POE

port on the PoE Injector.