User's Manual

Base Station Configuration Tsunami MP.16 3650 System User Guide
Logging Configuration
99
Logging Configuration
From the Logging Configuration page, you can set the parameters for the logging functions of the BS.
Figure 3-55 Logging Configuration
The following logging parameters can be configured or viewed:
• Filter Level: For both the volatile (stored in RAM) and non-volatile (stored in Flash), select the minimum logging level.
• Logging Output: Select the desired output locations:
–Select Volatile Log to save the log to the RAM. Note that information stored to the RAM may be lost in the event
of a power cycle.
–Select Non-Volatile Log to save the log to the flash.
• Clear Logs: Press Delete to clear the contents of the specified log.
• Module IDs: Select the modules for which logging should be enabled.
Once logging is configured, logs can be viewed on the Logs page.