User's Manual

Base Station Configuration Tsunami MP.16 3650 System User Guide
Service Class Creation
85
Service Class Creation
NOTE: You must reboot the SS for any configuration changes to take effect.
The steps for creating SS classes are as follows:
• PIR Creation
• Service Flow Creation
• Subscriber Station Class Creation
– Step 1: Select Service Flows
– Step 2: Associate PIRs with Service Flows
– Step 3: Networking Parameters
PIR Creation
From the Packet Identification Rule List page, you can create, delete, and edit up to 512 PIRs that identify specific traffic
types, including those that are predefined for you (see Pre-Defined PIRs).
1. Click Service Class Creation > PIRs
Figure 3-41 Packet Identification Rule List
2. Do one of the following:
• Click Add to create a new PIR.
• Click the radio button next to one of the PIRs and click Clone to make a copy of that PIR.
• Click the radio button next to one of the PIRs and click Edit to edit an existing PIR.
• Click the radio button next to one of the PIRs and click Delete to delete that PIR from the list.
3. If you are adding or cloning a PIR, specify a unique PIR Name between 1 and 32 characters, and click Add.