User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Subscriber Station: Logging Configuration
157
MP16>configure radio
The prompt will change to:
MP16(radio)>
From the radio prompt, you can show or set the following parameters:
Logging Configuration
To configure logging related parameters, enter the following command at the root prompt:
MP16>configure log
The prompt will change to:
MP16(log)>
From the log configuration prompt, you can set or show the following logging configuration parameters:
To view all logs of a specified level for a particular module:
MP16(log)>show logmodid <value>
To view all logs for a particular module:
Name Type Values Access Parameter
Base Station ID MacAddress Valid MAC address RW bsid
Center Frequency Integer 3650000 - 3675000
(in steps of 250)
Default: 3685000
RW centerfreq
Channel Bandwidth Integer 3.5
7
auto (default)
RW chbandwidth
Name Type Values Parameter
Logging Filter Level Integer none
emergency
alert
critical
error
warning
notice
informational
debug
loglevel
Logging Filter – Module IDs DisplayString dhcp
tftp
mac
bridge
snmp
netentry
pa
logmodid
Logging Output Interfacebitmask 00000000 (0x00): No logging
00000001 (0x01): RAM
00000010 (0x02): NVRAM
00000111 (0x04): Logging in RAM,
NVRAM
logop