User's Manual

Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: Service Class Creation
144
Subscriber Station Class Parameters
Adding Service Flows to an SS Class
You can add up to 16 Service Flows to the Subscriber Station Class.
To add a service flow for a Subscriber Station class:
MP16(SS Class name)>add sfclass <service flow class name> <type>
where <type> is one of the following:
• IPv4 ENET: Use this type when associated PIRs use at least one IP classifier and no VLAN classifiers. Ethernet
classifiers are optional.
• IPv4 VLAN: Use this type when associated PIRs use at least one IP classifier and one VLAN classifier.
• ENET 802.3: Use this type when associated PIRs use only Ethernet classifiers.
• VLAN 802.1Q: Use this type when associated PIRs use only VLAN classifiers.
NOTE: If the Service Flow has not yet been defined, or if the Service Flow is already added to the SS class, an error
message will be displayed.
Associating PIRs with Added Service Flows
For each service flow, you can associate up to 16 PIRs.
To add a PIR to a Service Flow within the context of a particular Subscriber Station class:
MP16(SS Class name)>add pir <SF Class name> <PIR name> <priority>
where <priority> is a value between 1 and 255.
NOTE: If the PIR has not yet been defined, or if the Service Flow already has the maximum number of PIRs added to it,
an error message will be displayed.
Name Type Values Access Parameter
VLAN Mode Integer transparent (default)
access
trunk
mixed
RW vlanmode
VLAN ID (used in Access
Mode or Trunk mode)
(see Access Mode and
Trunk Mode)
Integer 1 – 4095 RW vlanid
Management Priority
(used in Access mode)
(see Access Mode)
Integer 0 – 7 RW priority
Access ID (used in
Mixed mode) (See Mixed
Mode)
Integer 1 – 4095 RW accessid
Access Priority ((used in
Mixed mode) (See
Mixed Mode)
Integer 0 – 7 RW accesspriority
Trunk ID (used in Mixed
mode) (See Mixed
Mode)
Integer 1 – 4095 RW trunkid