User's Manual

Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: Radio Parameters
137
The prompt will change to:
MP16(radio)>
From the radio configuration prompt, you can show or set parameters in the following categories:
• Radio Parameters
• Downlink Burst Profile Table
• Uplink Burst Profile Table
Radio Parameters
Downlink Burst Profile Table
You can enable/disable each modulation type in the Downlink Burst Profile Table.
* The modulation type is the index to this table. See example.
To enable/disable an entry in the Downlink Burst Profile Table:
MP16>set dnlinkburstprofile feccodetype <modulation type> status <enable/disable>
Uplink Burst Profile Table
You can enable/disable each modulation type in the Uplink Burst Profile Table.
Name Type Values Access Parameter
Channel Bandwidth Integer 3.5
7
RW chbandwidth
Center Frequency Integer 3650000 - 3675000
(in steps of 250)
Default: 36850365000
RW centerfreq
Transmit Power Integer 5 - 21 dBm (in steps of 1 dBm)
Default: 21 dBm
RW txpower
Downlink Burst Profile
Table
—See Downlink Burst Profile
Table
—See Downlink Burst
Profile Table
Uplink Modulation — See Uplink Burst Profile Table —See Uplink Burst
Profile Table
Name Type Values Access Parameter
Downlink Burst Profile
Table
Integer — R dnlinkburstprofile
Modulation Type* Integer bpsk_1_2
qpsk_1_2
qpsk_3_4
qam16_1_2
qam16_3_4
qam64_2_3
qam64_3_4
R feccodetype
Status Integer enable (default)
disable
RW status
Name Type Values Access Parameter
Uplink Burst Profile
Table
Integer — R uplinkburstprofile