User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: Base Station Parameters
134
To set the IP Address and Mask:
MP16>configure bs
MP16(bs)>set ipaddr <interface> <ipaddress> <mask>
where <interface> is either Ethernet (enet0) or Wireless (rf1).
To set the maximum multicast downlink or maximum VLAN multicast downlink:
MP16>configure bs
MP16(bs)>set maxmcastdl <value> or set maxvlanmcastdl <value>
To set the Ethernet speed:
MP16>configure bs
MP16(bs)>set speed enet0 <value>
VLAN Mode/Management ID
* When setting the BS to Trunk mode, you must also configure the Management VLAN ID that will be used to manage the BS. The Manage-
ment VLAN ID must be one of the VLAN IDs configured in the VLAN ID List. When you set the BS to Trunk mode, your CLI session will be
terminated (stop responding). Reconnect to the CLI through a VLAN switch continue BS configuration.
To set the VLAN mode to Transparent:
MP16>configure bs
MP16(bs)>set vlanmode transparent
To set the VLAN mode to Trunk:
MP16>configure bs
MP16(bs)>set vlanmode trunk mgmtvlan <VLAN ID> mgmtpriority <0-7>
Static IP Routes
NOTE: Static Routes are configured using the add command.
To add a static IP route:
MP16>configure bs
MP16(bs)>add iproute <network> <mask> <gateway>
Ethernet Speed Integer 10fullduplex
10halfduplex
100fullduplex
100halfduplex
Auto
RW speed
Repeating Mode Integer enable
disable (default)
RW repeating
Name Type Values Access Parameter
VLAN Mode* Integer transparent
trunk
RW vlanmode
Management
VLAN ID* Integer 1 - 4095 RW mgmtvlan
Management Priority Integer 0-7 RW mgmtpriority
Name Type Values Access Parameter
Static IP Route — — — iproute
Name Type Values Access Parameter