User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Command Line Interface Tsunami MP.16 3650 System User Guide
Configuration from the Base Station: System Parameters
132
Configuration from the Base Station
Log into the Base Station and use the add, delete, set, and show commands to set or view parameters associated with
the following groups/tables:
• System Parameters: Configure parameters affecting the MP.16 system as a whole. Parameters include Broadcast
Bandwidth Control and Default Gateway.
• Base Station Parameters: Configure Device, Base Station ID, Net Entry Mode, IP Addresses and Masks, Ethernet
Interface parameters, Bridging parameters, and VLAN Mode/Management ID parameters.
• MAC Parameters: Configure MAC parameters
• Radio Parameters: Configure Radio, Uplink Burst Profile, and Downlink Burst Profile parameters
• VLAN ID List
• Subscriber Station List
• Service Class Creation
– Subscriber Station Classes
– Service Flows
– Packet Identification Rules
• Logging Configuration
• Trap Host Parameters
• Management Interface Parameters
System Parameters
The parameters that affect the system as a whole are grouped under System. To configure the parameters under the
System group, you must get into the System configuration prompt, which is done by entering the following command:
MP16>configure system
The prompt will change to:
MP16(system)>
From the system configuration prompt, you can show or set parameters from the following groups:
• Broadcast Bandwidth Control
• Default Gateway
Broadcast Bandwidth Control
Default Gateway
Name Type Values Access Parameter
Broadcast Bandwidth
Control
Broadcast
Bandwidth
Control
TBD RW bcastbwctrl
Name Type Values Access Parameter
Gateway IP Address IP Address User defined RW dfltgateway