User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Command Line Interface Tsunami MP.16 3650 System User Guide
CLI Overview: Commands
130
Then enter the set command from the configure prompt:
MP16 (group name)>set <parameter 1> <value 1> . . . <parameter N> <value N>
For example, to set the system name:
MP16>configure bs
MP16(bs)> set sysname MP16 location office
In the above example, the system name and location parameters are being modified.
NOTE: You may also set parameters in a single step by entering the configure and set commands in one command
line from the root prompt, as follows:
configure bs set sysname MP16 location office
Show Command
Use the show command from the root or the configure prompt to display the values of parameters or table entries, and to
view statistics and diagnostic tools.
The valid syntax for the show command is as follows:
For information on statistics and diagnostics viewable with the show command, see Monitoring the BS and SS.
Command Result Availability
show ? Displays a list of showable groups and
statistics.
BS and SS (root prompt and
configure prompt)
show Displays all configured parameters in a
group
BS and SS (configure prompt
only)
show <statistics, group, or
table name>
Displays all configured parameters in a
group or table, or shows statistics.
BS and SS (root prompt and
configure prompt)
show pir Displays a list of all PIRs. BS (root prompt)
show pir <PIR name> Displays configured parameters for a
particular PIR.
BS (root prompt)
show ssclass Displays a list of all SS Classes. BS (root prompt)
show ssclass <SS Class name> Displays configured parameters for a
particular SS Class.
BS (root prompt)
show sfclass Displays a list of all SF Classes. BS (root prompt)
show sfclass <SF Class name> Displays configured parameters for a
particular SF Class.
BS (root prompt)
show sysloghost Displays a list of all Syslog Servers BS and SS (root prompt)
show sysloghost <IP Address> Displays all configured parameters of a
particular Syslog Server
BS (root prompt)
show sysinvmgmt Displays hardware and software
components of the BS or SS
BS and SS (root prompt)
show tftpconf Displays a list of all configured hardware IDs BS (root prompt)
show tftpconf <Hardware ID> Displays all configured parameters of a
particular configured hardware ID
BS (root prompt)
show traphost Displays a list of all configured Trap Hosts BS (root prompt)
show traphost <IP Address> Displays all configured parameters of a
particular Trap Host
BS (root prompt)