User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Base Station Configuration Tsunami MP.16 3650 System User Guide
Service Class Creation
92
Step 1: Select Service Flows
Figure 3-49 SS Class Creation Step 1: Select Service Flows
4. Under the Available Service Flows heading, select a Service Flow and Type that are to be used for this class, and click
the right arrow . To remove a service flow, select it and click the left arrow. At least one uplink and one downlink
service flow must be defined. Select a Service Flow Type, based on the following:
• IPv4 ENET: Use this type when associated PIRs use at least one IP classifier and no VLAN classifiers. Ethernet
classifiers are optional.
• IPv4 VLAN: Use this type when associated PIRs use at least one IP classifier and one VLAN classifier.
• ENET 802.3: Use this type when associated PIRs use only Ethernet classifiers.
• VLAN 802.1Q: Use this type when associated PIRs use only VLAN classifiers.
5. Click Save & Next.
The Step 2: Associate PIRs with Service Flow page will be displayed. This page contains a section for each Service
Flow you added in Step 1.