User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Base Station Configuration Tsunami MP.16 3650 System User Guide
Service Class Creation
89
Figure 3-45 Add Service Flow Classes Screen
The Service Flow Class Configuration page will be displayed.
Figure 3-46 Service Flow Class Configuration Page
4. Configure the Service Flow Class parameters:
• Scheduling Type: The traffic scheduling mechanism used by the uplink or downlink. Select one of the following:
– Best-Effort Service (BE): This mechanism is defined by the following QoS parameters: maximum sustained
data rate and traffic priority. See below.
– Non Real-Time Polling Service (nrtPS): This mechanism is defined by the following QoS parameters: maximum
sustained data rate, minimum reserved traffic rate, and traffic priority. See below.
– Real-Time Polling Services (rtPS): This mechanism is defined by the following QoS parameters: maximum
sustained data rate, minimum reserved traffic rate, and maximum latency. See below.