User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Base Station Configuration Tsunami MP.16 3650 System User Guide
Subscriber Station List
79
Configuring an Individual SS for Trunk Mode (Override)
If the BS’s VLAN mode is set to Trunk, the SS’s VLAN mode may be set to Trunk. With the SS’s VLAN mode set to Trunk,
the following screen will be displayed:
Figure 3-38 SS VLAN Configuration Override (Trunk Mode)
In Trunk mode, up to 16 VLAN IDs may be specified as having access to the SS. Additionally, one of these VLAN IDs
must be designated as the VLAN Management ID for the VLAN.
NOTE: The total number of VLANs and Service Flows must not exceed 20.
Set the following parameters and click OK:
• VLAN Management ID: Select one VLAN ID from the Selected Trunk VLAN ID List to serve as the Management ID.
Only VLAN packets tagged with this ID will have management access to the SS. If the VLAN ID entered in this field is
not contained in the Selected Trunk VLAN ID List, an error message will be displayed when you click OK.
• Selected VLAN ID List: You may add up to 16 VLAN IDs to this list. To add a VLAN ID, select the VLAN ID from
Available VLAN ID List, and click the right arrow . To remove a VLAN ID from the list, select the ID and click the
left arrow.
NOTE: After clicking OK, the selected Management ID will be automatically moved to the top of the Selected Trunk
VLAN ID List.
For information on configuring the Available VLAN ID List, see VLAN ID List.