User's Manual
Table Of Contents
- Introduction
- Installation and Initialization
- Hardware Description
- System Requirements
- Product Package
- Hardware Installation
- Step 1: Choose a Location
- Step 2: Unpack Shipping Box
- Step 3: Assemble the Cable
- Step 4: Determine Proper Mounting Orientation
- Step 5: Assemble Mounting Hardware
- Step 6: Mount the Unit
- Step 7: Plug in the Cables
- Step 8: Power on the Unit
- Step 9: View LEDs
- Step 10: Align the Antenna
- Step 11: Tighten the Cables
- Step 12: Weatherproof the Connectors
- Step 13: Install Documentation and Software
- Using the Web Interface
- Installing Latest Software
- First Configuration
- Base Station Configuration
- Introduction
- System Configuration
- MAC Configuration
- Radio Configuration
- Radio Downlink Burst Profile Configuration
- Radio Uplink Burst Profile Configuration
- Networking Configuration
- Global Positioning System (GPS)
- Subscriber Station Authentication
- Subscriber Station List
- Service Class Creation
- Logging Configuration
- Management Interface Configuration
- Subscriber Station Configuration
- Commands on BS/SS
- Log Messages on the BS/SS
- Monitoring the BS and SS
- Technical Specifications
- Command Line Interface
- CLI Overview
- Configuration from the Base Station
- Configuration from the Subscriber Station
- Monitoring the BS and SS
- Technical Services and Support
- Statement of Warranty
Base Station Configuration Tsunami MP.16 3650 System User Guide
Subscriber Station List
76
4. Specify an Uplink Modulation for the SS. When adaptive is selected, the SS will continually monitor and adjust to
select the best modulation for the link conditions.
5. Specify an Downlink Modulation for the SS. When adaptive is selected, the SS will continually monitor and adjust to
select the best modulation for the link conditions.
6. Set the VLAN parameters of the SS:
• To use the VLAN parameters associated with the assigned SS Class, select Inherited from the VLAN Mode
drop-down menu, and click OK. The VLAN Management ID configured with the SS Class will be used; this field is
not configurable here.
• To override the VLAN parameters associated with the assigned SS Class, select Transparent, Access, Trunk, or
Mixed from the drop-down menu. and configure parameters as described in the following sections:
– To set the VLAN mode to Transparent, see Configuring an Individual SS for Transparent Mode (Override)
– To set the VLAN mode to Access, see Configuring an Individual SS for Access Mode (Override)
– To set the VLAN mode to Trunk, see Configuring an Individual SS for Trunk Mode (Override)
– To set the VLAN mode to Mixed, see Configuring an Individual SS for Trunk Mode (Override)
–
NOTE: To reset an override to the value specified by the SS Class, set VLAN Mode to Inherited.